TrailBlazer 2WD V8-6.0L VIN H (2006)
^
Tighten the front lower control arm bracket mounting bolt to 265 Nm (195 ft. lbs.).
^
Tighten the rear lower control arm bracket mounting bolts to 240 Nm (177 ft. lbs.).
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the lower control arm to the lower control arm bracket.
4. Install the lower control arm to lower control arm bracket mounting bolts.
5. Install the lower control arm to lower control arm bracket mounting nuts.
Tighten the nuts to 130 Nm (96 ft. lbs.).
Important: Ensure that the lower control arm is parallel to the lower control arm bracket during the installation and tightening of the lower
control arm mounting bolts and nuts. This will ensure correct alignment of the lower control arm bushings.
6. Install the stabilizer shaft link and washer to the lower control arm.
Important: There is a washer between the stabilizer shaft link and the lower control arm made of hardened steel and has a felt inner liner. Only
replace this washer with an identical washer. Standard washers should not be used.
7. Install the stabilizer shaft link retaining nut.
Tighten the nut to 155 Nm (114 ft. lbs.).
8. Install the tire and wheel.
9. Lower the vehicle.
10. Inspect the front wheel alignment.
Upper Control Arm Replacement
Upper Control Arm Replacement
Removal Procedure
