TrailBlazer 2WD V8-6.0L VIN H (2006)
6. Place the top half of the J41048 on the bottom half.
7. Inspect to make sure there are no pinch points on the boot before proceeding.
8. Insert the bolts (2).
9. Tighten the bolts (2) by hand until snug.
10. Align the following items:
^
The boot
^
The halfshaft bar
^
The swage clamp
Each bolt 180 degrees at a time, using a ratchet wrench. Alternate between each bolt until both sides are bottomed.
Notice: Refer to Fastener Notice in Service Precautions.
11. Loosen the bolts.
12. Separate the dies.
13. Inspect the swage clamp for any "lip" deformities.
Important: If deformities exist in the swage clamp, place the swage clamp back into J41048. Ensure the swage clamp covers the whole swaging
area. Re-swage the swage clamp.
