TrailBlazer 4WD L6-4.2L VIN S (2002)
6. Remove the antenna mast.
7. Open the hood.
8. Remove the radio antenna cable assembly retaining screws.
9. Pass the antenna cable and grommet assembly through the fender opening.
10. Remove the radio antenna cable assembly from the vehicle.
INSTALLATION PROCEDURE
1. Install the radio antenna cable assembly to the vehicle.
2. Pass the antenna cable and grommet assembly through the fender opening.
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the radio antenna cable assembly retaining screws.
Tighten
Tighten the radio antenna cable assembly screws to 2.8 N.m (25 lb in).
4. Close the hood.
5. Install the antenna mast.
