TrailBlazer 4WD L6-4.2L VIN S (2002)
Auxiliary Step / Running Board: All Technical Service Bulletins
Body - Assist Step Skid Pad Warping
File In Section: 08 - Body and Accessories
Bulletin No.: 02-08-61-002
Date: June, 2002
TECHNICAL
Subject:
Assist Step Skid Pad Warping (Replace Skid Pad)
Models:
2002 Chevrolet TrailBlazer EXT
2002 GMC Envoy XL
with Side Step Running Board (RPO BVE)
Built Prior to May, 2002
Condition
Some customers may comment that the assist step skid pad is warped.
Cause
The fasteners on the bottom side of the skid pad have interference to the attaching slots in the metal plate of the step assembly. This interference causes
the pad to warp between the fasteners when exposed to sun and heat.
Correction
A new assist step skid pad has been released for service to correct this condition. This new pad has revised fasteners that provide more clearance to the
attaching slots in the metal plate. Replace the assist step skid pads using the procedure and part numbers listed below.
1.
Remove the assist step skid pad using a door trim panel tool.
2.
Install the new assist step skid pad. Ensure all fasteners are fully seated.
3.
Repeat the above steps for the opposite side.
Parts Information
Parts are currently available from GMSPO.
Warranty Information