TrailBlazer 4WD L6-4.2L VIN S (2002)
4. Drill a 13 mm (1/2 in.) hole at each pilot hole location (2).
5. Clean and prepare all bare-metal surfaces.
IMPORTANT: Prior to refinishing, refer to the publication GM4901MD-01 GM Approved Refinish Materials for recommended products. Do
not combine paint systems. Refer to paint manufacturer's recommendations.
6. Apply an anti-corrosion primer.
7. Pass the feed wire (1) through the hinge (2), body pillar (3) and backing plate (4) as shown.
8. Crimp the feed wire (1) behind the backing plate.
9. Pull the feed wire (1) while guiding the backing plate (2) into the inner structure.