TrailBlazer 4WD L6-4.2L VIN S (2002)
4. Attach the molding to the outside of the door with double sided tape.
NOTE: Refer to Fastener Notice in Service Precautions.
5. Install the weatherstrip/run channel retaining bolt.
Tighten
Tighten the bolt to 10 N.m (88 lb in).
6. Install the window.
7. Install the water deflector.
8. Install the outer window belt sealing strip.
9. Install the inner window belt sealing strip.
10. Install the trim panel.
Trailblazer EXT, Envoy XL
REMOVAL PROCEDURE
1. Remove the trim panel.
2. Remove the inner window belt sealing strip.
3. Remove the outer window belt sealing strip.
4. Remove the water deflector.
5. Remove the window regulator.
6. Carefully lower the glass into the door.
7. Remove the bolt (2) that retains the weatherstrip run channel to the door.
8. Pull the weatherstrip (1) loose from the window frame opening.
9. Release the clip retaining the quarter glass to the window opening by pulling forward on the run channel (4).
IMPORTANT: The quarter glass and weatherstrip/run channel is not serviceable and should be replaced only as an assembly.
10. Remove the weatherstrip run channel assembly from the top of the door opening.
INSTALLATION PROCEDURE