TrailBlazer 4WD L6-4.2L VIN S (2002)
bulkhead.
3. Install the cable to the release handle (3).
4. Seat the cable grommet (1) to the bulkhead.
5. Install the release handle (3) to the left side cowl panel.
Notice: Refer to Fastener Notice in Service Precautions.
6. Install the nut (2) that retains the release handle (3) to the left side cowl panel.
Tighten the nut to 7 N.m (62 lb in).
7. Route the cable as previously noted, over the battery tray, between the headlamp panel assembly and the radiator.
8. Attach the cable to the retainers on the wheelhouse and the hood hold open rod bracket.
9. Install the cable to the hood latch assembly.
10. Install the hood latch.
11. Install the front grille.
12. Install the left closeout/insulator panel.
13. Install the left front door sill panel.