TrailBlazer 4WD L6-4.2L VIN S (2002)
5. Route the wire harness until fully seated into the sunshade wire harness channel located on the pivot arm.
IMPORTANT: If the wire harness retaining clip is removed from the sunshade for any reason, a new retaining clip must be installed.
6. Position the wire harness retaining clip between the headliner and the roof panel.
7. Position the index tabs on the wire harness retaining clip to the pivot arm and install the clip until fully seated. With the wire harness retaining clip
installed, the sunshade should remain attached to the headliner.