TrailBlazer 4WD L6-4.2L VIN S (2002)
Trim Panel: Service and Repair
Garnish Molding Replacement - Center Pillar
Garnish Molding Replacement - Center Pillar
Removal Procedure
1. Remove the front and rear door sill plates.
2. Move the seat to a forward position.
3. Release the 4 retaining clips that attach the garnish molding to the center pillar.
4. Disconnect the electrical connector from the temperature sensor, if equipped.
5. Remove the garnish molding from the vehicle.
Installation Procedure
1. Position the garnish molding to the center pillar.
2. Connect the electrical connector to the temperature sensor, if equipped.
3. Index the positioning tabs on the garnish molding to the corresponding holes in the center pillar.
4. Seat the 4 garnish molding retaining tabs to the center pillar.
5. Return the seat to neutral position.
6. Install the front and rear door sill plates.