TrailBlazer 4WD L6-4.2L VIN S (2002)
8. Partially remove the trim panel in order to remove the inflator switch from the inflator bezel.
9. Remove the auxiliary air outlet washer and retaining nut.
10. Feed the auxiliary air outlet through the inflator bezel.
11. Remove the inflator bezel from the trim panel.
12. Disconnect the the 12-volt power supply electrical connector.
13. Remove the 12-volt power supply.
14. Remove the trim panel from the vehicle.
INSTALLATION PROCEDURE
1. Position the trim panel to the vehicle.
2. Install the 12-volt power supply.
3. Connect the 12-volt power supply electrical connector.
4. Install the inflator bezel to the trim panel.
5. reed the auxiliary air outlet through the hole in the inflator bezel.
NOTE: Refer to Fastener Notice in Service Precautions.
6. Install the auxiliary air outlet washer and retaining nut.
Tighten
Tighten the nut to 2 N.m (18 lb in).
7. Install the inflator switch to the inflator bezel.