TrailBlazer 4WD L6-4.2L VIN S (2002)
8. Release the five screws that retain the rear quarter trim panel to the body.
9. Remove the rear quarter trim panel from the vehicle.
INSTALLATION PROCEDURE
1. Position the trim panel to the vehicle.
2. Position the seat belt over the top of the trim panel, ensuring that the buckle is not behind the trim panel.
3. Index the locating tabs on the trim panel to the holes in the body.
4. Connect the wiring harness connector to the auxiliary power outlet.
NOTE: Refer to Fastener Notice in Service Precautions.
5. Install the five screws that the retain the rear quarter trim panel to the body.
Tighten
Tighten the rear quarter trim panel screws to 2.5 N.m (22 lb in).
6. Install the seat belt lower anchor.
Tighten
Tighten the seat belt anchor bolt to 70 N.m (52 lb ft).
7. Install the right rear door sill panel.
8. Install the liftgate sill plate.
9. Install the right body side window forward garnish molding.
10. Install the right body side window rear garnish molding.
