TrailBlazer 4WD L6-4.2L VIN S (2002)
10.
Remove the inboard retainer screw.
11.
Remove the inboard retainer (1) from the headliner.
12.
If the vehicle is equipped with lighted sunshades, perform the following steps.
12.1. Reach above the headliner to access the electrical connector (1).
12.2. Remove the electrical connectors from the headliner substrate.
12.3. Disconnect the sunshade electrical connector from the headliner harness.
13.
Remove the sunshade from the vehicle.
Installation Procedure
1.
If the vehicle is equipped with lighted sunshades, perform steps 2 through 8.
2.
Lower the headliner in order to gain access to the wire harness.
3.
Position the sunshade to the headliner.
4.
Connect the sunshade electrical connector to the headliner harness.
