TrailBlazer 4WD L6-4.2L VIN S (2002)
1. Position the latch bracket to the seat hinge.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the latch bracket bolts (2) that retain the latch bracket to the seat hinge.
Tighten
Tighten the latch bracket bolts to 35 N.m (26 lb ft).
3. Install the seat back to the vehicle.
Mid-Position Floor Latch Assembly Replacement - Rear No. 1
REMOVAL PROCEDURE
1. Remove the seat from the vehicle.
2. Remove the trim panel from the seat cushion.
3. Remove the rear center seat belt buckle assembly from the floor latch assembly.
4. Remove the cable (3) from the mid-position floor latch assembly (2).
5. Remove the bolts (1) securing the mid-position floor latch assembly to the seat cushion frame.
6. Remove the mid-position floor latch assembly.
INSTALLATION PROCEDURE
NOTE: Refer to Fastener Notice in Service Precautions.