TrailBlazer 4WD L6-4.2L VIN S (2002)
Rear Door Window Glass Weatherstrip: Service and Repair
Door Window Channel
Trailblazer, Envoy, Bravada
REMOVAL PROCEDURE
1. Remove the trim panel.
2. Remove the inner window belt sealing strip.
3. Remove the outer window belt sealing strip.
4. Remove the water deflector.
5. Remove the window.
6. Remove the bolt that retains the weatherstrip run channel to the door.
7. Pull the weatherstrip/run channel from the window frame opening.
8. carefully release the double sided tape attaching the molding to the outside of the door.
9. Carefully twist the weatherstrip run channel and pull up at the top of the door frame.
IMPORTANT: The quarter glass and weatherstrip/run channel is not serviceable and should be replaced only as an assembly.
10. Remove the weatherstrip/run channel from the door.
INSTALLATION PROCEDURE
1. Install the weatherstrip/run channel to the door.
2. Press the weatherstrip/run channel into the window frame opening.
3. Position the tabs on the weatherstrip/run channel into the slots on the door.