TrailBlazer 4WD L6-4.2L VIN S (2002)
1. Install the park brake cables over the fuel tank assembly.
2. Pull the park brake cable through the frame toward the outside of the vehicle.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the park brake cable retaining nuts to the underbody mounting studs.
^
Tighten the park brake cable retaining nuts to 10 Nm (7 ft. lbs.).
4. Raise the fuel tank the fuel tank to allow access to the rear park brake cable retainer above the fuel tank.
5. Install the rear support bracket for the fuel tank.
6. Remove the pole jack and the block of wood from the fuel tank.
