TrailBlazer 4WD L6-4.2L VIN S (2002)
Side Air Bag: Service and Repair
Inflatable Restraint Side Impact Module Replacement - Front
INFLATABLE RESTRAINT SIDE IMPACT MODULE REPLACEMENT - FRONT
REMOVAL PROCEDURE
CAUTION: Following the deployment of a side impact air bag, inspect the following parts for damage. Replace these parts if necessary:
^
The seat cushion frame
^
The seat recline, if equipped
^
The seat adjuster
^
The seat back frame
Failure to do so may cause future personal injury.
1. Disable the SIR system. Refer to Air Bag(s) Arming and Disarming.
2. Remove the seat assembly from the vehicle.
3. Remove the seat trim panel.
4. Remove the seat back cover and pad.
5. Remove the front seat back panel.
6. Remove the push pin (2) securing the top of the seat belt retractor assembly to the seat back frame.
7. Remove the 2 screws (1) that secure the inflatable side impact module to the seat back frame.
8. Disconnect the SIR wiring harness from the module.
9. Remove the side impact module.
10. Fully deploy the module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required
retention period. Refer to Inflator Module Handling and Scrapping.