TrailBlazer 4WD L6-4.2L VIN S (2002)
5. Remove all loose objects from the front seats.
6. Disconnect the inflatable restraint steering wheel module coil connector, located behind the glove compartment.
IMPORTANT: If the vehicle is equipped with dual stage air bags, the steering wheel module and the IP module will each have 4 wires. Refer to SIR
Connector End Views for determining the high and low circuits.
7. Cut the yellow harness connector from the vehicle, leaving at least 16 cm (6 in) of wire at the connector.
B. Strip 13 mm (0.5 in) of insulation from all 4 SIR wires connector leads.
9. Cut two 4.6 m (15 ft) deployment wires from a 0.8 mm (18 gage) or thicker multi-strand wire. These wires will be used for the steering wheel
module deployment harness.
10. Strip 13 mm (0.5 in) of insulation from both ends of the wires cut in the previous step.
11. Twist together one end from each of the wires in order to short the wires. Deployment wires shall remain shorted, and not connected to a power
source until you are ready to deploy the inflator module.
