TrailBlazer 4WD L6-4.2L VIN S (2002)
5. Firmly pull rack and pinion boot (1) from the gear.
Discard the rack and pinion boot (1)
Installation Procedure
Important: The arrows (2) on the boot must be aligned with the range (1) on the gear housing.
1. Apply grease provided to inside of rack and pinion boot ribs (4).
2. Place the new large seal retaining clamp (3) onto rack and pinion boot (4).
3. Install boot (4) over inner tie rod end. Align the arrows (2) on boot (4) with the range (1) marked on the gear housing.
4. Install the new small seal retaining clamp (2) over the boot (1).
5. Slide the boot (1) towards the center of the gear assembly until the boot seats in the inner tie rod retaining groove.
Important: The boot (1) must not be twisted, puckered or out of shape in any way. If the rack and pinion boot (1) is not shaped properly, adjust by
hand before installing the boot clamps (3,4). Be sure arrows on the boot (1) align with range on the gear housing.
