TrailBlazer 4WD L6-4.2L VIN S (2002)
5.
With the applicator hose down as far as possible toward the mating area of the serrations, spray a generous amount of grease.
6.
Repeat the application after rotating the steering wheel 180 degrees, so that the serrations are treated in two locations opposite each other.
7.
Position the floor air outlet duct into place and install the push pin retainer.
8.
Raise the insulator panel and install the retaining clip to the IP substrate.
9.
Install the two screws that retain the left closeout/insulator panel to the IP.
Use the following steps to remove material from the upper intermediate shaft bushing.
1.
Push the upper intermediate shaft boot seal (2) down toward the floor in order to completely expose the white bushing (1).
2.
Using fine or very fine sandpaper, remove material from the intermediate shaft bushing. Sand around the entire face of the bushing sufficient
enough to obtain clearance and reduce the drag between the intermediate shaft bushing and the upper boot seal.
3.
Return the upper intermediate shaft boot seal to its original position.
4.
Clean debris as necessary.
Parts Information
Warranty Information
