TrailBlazer 4WD L6-4.2L VIN S (2002)
11. Verify the pin can be removed and installed with ease to ensure the correct sensor installation. If the pin cannot be inserted with ease, loosen the
sensor fasteners, adjust the sensor, and retighten the sensor fasteners until the pin can be removed and installed with ease.
Notice: Failure to remove the air suspension auto level control sensor locating pin will cause damage to the air suspension auto level control
sensor.
12. Remove the air spring level sensor locating pin.
13. Perform the sensor calibration for the right side.
Raise or lower the vehicle so the left side D-height is 110 mm from the right side of the vehicle.
14. Raise the vehicle off the jackstands and remove the jackstands from under the vehicle.
15. Install the rear tires and wheels.
16. Lower the vehicle.
17. Install the air suspension fuse.
18. Turn the ignition key to the ON position to inflate the rear air springs.
19. After two minutes, turn the ignition key to the OFF position.
20. Recycle the ignition, if needed.
21. Verify and record the D-height.