TrailBlazer 4WD L6-4.2L VIN S (2002)
Important: When performing this service procedure, make sure that the motor/encoder unit is flat against the transfer case for proper installation.
1. Install the motor/encoder to the transfer case.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install motor/encoder mounting bolts to the transfer case.
Tighten
Tighten the bolts to 16 Nm (12 lb ft).
3. Install the motor/encoder electrical connector.
4. Install the transfer case shield, if equipped.
5. Lower the vehicle.