TrailBlazer 4WD L6-4.2L VIN S (2002)
17. Align the swage clamp (2) within J41048.
18. Place the top half of the J410480n the bottom half.
19. Check to make sure there are no pinch points on the seal before proceeding with procedures.
20. Insert the bolts (2). Tighten the bolts (2) by hand until snug.
Notice: Refer to Fastener Notice in Service Precautions.
21. Align the following items:
^
The seal
^
The halfshaft bar
^
The swage clamp
^
Tighten each bolt 180 degrees at a time, using a ratchet wrench. Alternate between each bolt until both sides are bottomed.
22. Loosen the bolts.
23. Separate the dies.
24. Check the swage clamp for any "lip" deformities. If the deformities exist, place the swage clamp back into the J4104B.
Important: Ensure that the retaining ring side of the CV joint inner race faces the halfshaft bar (1) before installation.
25. Place the retaining snap ring into the CV joint inner race.
