TrailBlazer 4WD L6-4.2L VIN S (2002)
^
The underside of the rear defogger bus bar lead wire
^
The defogger terminal
7. Align the spots with the flux to the appropriate areas:
^
The underside of the rear defogger bus bar lead wire
^
The defogger terminal
8. Coat the tip of the soldering iron with solder.
9. Solder the appropriate areas:
^
The underside of the rear defogger bus bar lead wire
^
The defogger terminal
10. Draw the iron across the fluxed spot. Thinly coat the spot with solder.
11. Solder the spot on the braid against the spot on the feed bus bar or the ground bus bar.
12. Use pliers in order to hold the appropriate component:
^
The rear defogger bus bar lead wire
^
The defogger terminal
13. Apply heat to the appropriate area in order to ensure the solder spot melts and fuses together:
^
The top of the rear defogger bus bar lead wire
^
The defogger terminal
IMPORTANT: Do not remove the holding force until the solder has solidified.
14. Remove the excess flux with the solvent.
15. Connect the electrical connector.
