TrailBlazer 4WD L6-4.2L VIN S (2002)
8. Install the upper reveal molding.
8.1.
Start from the center and hand-press the reveal molding into place over the edge of the windshield.
8.2.
Install both right and left sides of the reveal molding.
8.3.
Run warm water over the reveal molding in order to speed the setup time of the urethane adhesive.
Tape should be applied in order to retain the reveal molding to the windshield, this will maintain a flush fit with the body.
The tape is to be removed after 6 hours.
Windshield Side Reveal Molding Replacement
REMOVAL PROCEDURE
1. Open the front door.
Remove the push pin retainers (2) from the front door sealing weatherstrip located at the base of the pillar.
