TrailBlazer 4WD V8-6.0L (2007)
Auxiliary Step / Running Board: Service and Repair
Assist Step Replacement
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the nuts (1) that retain the assist step to the assist step support brackets.
3. Remove the assist step from the support brackets.
4. Place the assist step on a clean, prepared surface.
5. Release the fasteners (2) that retain the assist step pad to the assist step.
6. Remove the assist step pad from the assist step.
Installation Procedure
1. Install the assist step pad to the assist step, ensuring that the fasteners (2) are fully seated.
2. Position the assist step to the vehicle.
Notice: Refer to Fastener Notice.
Install the nuts (1) that retain the assist step to the assist step support brackets.
Tighten the nuts to 25 N.m (18 lb ft).
3. Lower the vehicle. Refer to Vehicle Lifting.