TrailBlazer 4WD V8-6.0L (2007)
4. Inspect the rear output shaft bushing for scoring or wear.
5. Remove the rear output shaft bushing, if required, using the J 45380
1. Install the finger section of the J 45380
2. Install the tube and forcing screw to the finger section. Ensure the forcing screw is backed out.
3. Using a wrench on the forcing screw, remove the rear output shaft bushing.
Installation Procedure
1. Using the J 45380
1. Install the bushing or the finger section of the J 45380
2. Install the finger section to the main body of the J 45380
3. Position the bushing and tool to the case.
4. Using a hammer and the J 45380