Traverse AWD V6-3.6L (2011)
Rear Subframe: Service and Repair
Rear Suspension Support Lower Mount Replacement - Rear
Rear Suspension Support Lower Mount Replacement - Rear
Special Tools
J 45725 - Frame Bushing Installer
Removal Procedure
1. Remove the spare tire.
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
3. Remove the rear tire and wheel assemblies. Refer to Tire and Wheel Removal and Installation .
4. Remove the rear brake caliper bracket bolts.
Note: Support the rear brake calipers from the vehicle body not the suspension to prevent stressing of the brake hoses.
5. Support the rear brake caliper.
6. Support the exhaust system on a suitable stand and disconnect the rubber insulator hangers from the exhaust system.
7. Lower the exhaust only enough to allow lowering of the suspension crossmember 38 mm (1.5 in).
8. Install jackstands under the front and rear of the suspension crossmember.