Traverse AWD V6-3.6L (2011)
2. Reprogram the transmission control module (TCM). Refer to SI and Service Programming System (SPS) documentation for programming
instructions, if required.
1. Connect the MDI or Tech 2 to the vehicle.
2. Select J2534 MDI or J2534 Tech 2 and Reprogram ECU from the Select Diagnostic Tool and Programming Process screen.
3. Select TCM Transmission Control Module -- Programming from the Supported Controllers screen.
4. Follow the on-screen instructions.
3. Using the MDI, and either GDS or Tech 2, clear all DTCs, if required.
Claim Information
1. Submit a claim using the table above.
Disclaimer