Traverse FWD V6-3.6L (2009)
12. Remove the wiring harness retaining bolt.
13. Remove the engine wiring harness retaining clips (1) from the intake manifold.
14. Position the engine wiring harness aside.
15. Remove the intake manifold insulator.
16. Remove the intake manifold bolts (1).
17. Remove the intake manifold (2) with the throttle body.
18. If the intake manifold is being replaced, disassemble the intake manifold. Refer to Intake Manifold Disassemble (See: Service and
Repair/Overhaul).
19. Clean and inspect the intake manifold. Refer to Intake Manifold Cleaning and Inspection (See: Service and Repair/Overhaul).
Installation Procedure