Uplander AWD V6-3.5L VIN 8 (2005)
9.
Strip approximately 7.5 mm (5/16 in) of insulation from the BK/WH ground wire (circuit no. 351). Connect the bare drain wire (circuit no. 814) to
the stripped 351 ground wire and tape to secure.
10.
Tape the entire repair area.
11.
Install the DVD player to the roof.
12.
Connect the DVD player electrical connector.
13.
Install the mounting screws to the DVD player.
14.
Verify that the noise is eliminated or has been greatly reduced. This may take several minutes to allow the transformers to charge up.
Parts Information
Transformer Specifications
Warranty Information
For vehicles repaired under warranty, use the table.
Disclaimer