Uplander AWD V6-3.5L VIN 8 (2005)
Lower Sliding Door Roller: Service and Repair
Roller Bracket Replacement - Lower
Removal Procedure
Important: By removing the power sliding door (PSD) 15A fuse, the low current logic power for both the LH and RH power sliding door
modules (PSDM) will be interrupted and both PSDs will be inoperative.
1. If equipped with a power sliding door, disable the PSD system by removing the PSD 15A fuse from the instrument panel (I/P) fuse block.
2. Remove the front edges of the sliding door inner trim panel in order to gain access to the sliding door lower roller bracket bolts.
3. Mark the location of the sliding door lower roller bracket to the sliding door with a grease pencil.
4. Support the sliding door.
5. Remove the sliding door catch (1) with the reinforcement channel bolt (2) at the sliding door lower track.