Uplander AWD V6-3.5L VIN 8 (2005)
Body / Frame Mount Bushing: Service and Repair
Frame Cushion or Insulator Replacement - Front
Frame Cushion or Insulator Replacement - Front
Tools Required
J 45296 Frame Insulator Remover/Installer
Removal Procedure
1. Raise and support the vehicle. Refer toLifting and Jacking the Vehicle in General Information.
2. Disconnect the steering intermediate shaft. Refer toIntermediate Steering Shaft Replacement in Steering Wheel and Column.
3. Install a jackstand under the center of the frame, between the front frame insulators.
4. Remove the front frame bolts and retainers.
5. Lower the front of the frame.
6. Remove the frame front upper insulators.
7. Install theJ 45296 to the front frame insulator you are removing.
8. UsingJ 45296 , remove the front frame insulator from the frame.
Installation Procedure
1. Clean the front frame insulator opening.
2. Apply a thin coat of rubber lubricant GM P/N 1051717 (Canadian P/N 5728223), or equivalent to the inside of the front frame insulator opening.
3. Apply a thin coat of rubber lubricant GM P/N 1051717 (Canadian P/N 5728223), or equivalent to the front frame insulator.
