Uplander AWD V6-3.5L VIN 8 (2005)
Trim Panel: Service and Repair
Accessory Panel Replacement - Rear
Accessory Panel Replacement - Rear
Removal Procedure
1. Open the panel cover using the latch. Remove the cover from the hinges.
2. Remove the trim panel.
3. Disconnect the electrical connector.
Installation Procedure
1. Connect the electrical connector to the power outlet.
2. Install the trim panel.
3. Install the cover on the hinges. Close the cover.
Finish Panel Replacement - Upper Rear Trim
Finish Panel Replacement - Upper Rear Trim
Tools Required
J 38778 Door Trim Pad Clip Remover
Removal Procedure
1. Remove the upper seat belt anchor bolt from the belt guide loop.
Important: Use care to not break the locating tabs on the quarter trim when removing the back body pillar trim.
2. UsingJ 38778 remove the back body pillar trim from the vehicle.