Uplander AWD V6-3.5L VIN 8 (2005)
Installation Procedure
1. Install the back body pillar trim by aligning the trim with the locating tabs on the quarter trim.
2. Align the retainers in the holes and push to secure the retainers.
Notice: Refer toFastener Notice in Cautions and Notices.
3. Install the upper seat belt anchor bolt to the belt guide loop.
Tighten the bolt to 43 Nm (32 lb ft).
Garnish Molding Replacement - Sliding Door
Garnish Molding Replacement - Sliding Door
Removal Procedure
1. Carefully pull the sliding door garnish molding away from the sliding door in order to release the clips.
Be sure not to damage the garnish molding.
2. Remove the sliding door garnish molding from the sliding door.
Installation Procedure
1. Align the sliding door garnish molding clips to the holes in the sliding door.
2. Install the sliding door garnish molding to the sliding door.
3. Firmly press the sliding door garnish molding in order to secure the clips to the holes in the door.
Garnish Molding Replacement - Windshield Pillar
Garnish Molding Replacement - Windshield Pillar
