Uplander AWD V6-3.5L VIN 8 (2005)
1. Install the front door lock cylinder to the front door outside handle.
2. Install the lock cylinder retainer to the front door outside handle.
3. Install the front door outside handle. Refer toDoor Handle Replacement - Front Outside (See: Doors, Hood and Trunk/Doors/Front Door/Front
Door Handle/Front Door Exterior Handle/Service and Repair) .
Lock Cylinder Replacement - Rear Door (Liftgate)
Lock Cylinder Replacement - Rear Door (Liftgate)
Removal Procedure
1. Open the liftgate.
2. Remove liftgate trim panel. Refer toTrim Panel Replacement - Liftgate (See: Doors, Hood and Trunk/Trunk / Liftgate/Trunk / Liftgate Interior
Trim Panel/Service and Repair/Trim Panel Replacement - Liftgate) .
3. Remove the liftgate handle molding. Refer toHandle Replacement - Liftgate (See: Doors, Hood and Trunk/Trunk / Liftgate/Trunk / Liftgate
Handle/Service and Repair/Handle Replacement - Liftgate) .
4. Remove the nuts from the lock cylinder .
5. Disconnect electrical connector, if equipped.
6. Disconnect the lock rod from the cylinder.
7. Remove the lock cylinder from the liftgate.
Installation Procedure