Uplander AWD V6-3.5L VIN 8 (2005)
LUGGAGE CARRIER RIVNUT REPLACEMENT
REMOVAL PROCEDURE
1. Remove the luggage carrier.
2. Drill through the luggage carrier rivnut head using a 7.5 mm (0.295 in) drill bit.
CAUTION: Refer to Safety Glasses Caution in Service Precautions.
3. Remove the rivnut from the roof.
INSTALLATION PROCEDURE
1. Use a 10 mm (0.39 in) drill bit to drill the hole in the roof out.
2. Install a replacement rivnut to the hole in Sunroof/Moonroof using a rivnut tool, or equivalent.
3. Install the luggage carrier.
Luggage Carrier Cross Rail Replacement
LUGGAGE CARRIER CROSS RAIL REPLACEMENT
REMOVAL PROCEDURE
1. Remove the luggage carrier.
2. Turn the luggage carrier upside down and place on a clean flat surface.
3. Remove the luggage carrier cross rail screws from the luggage carrier side rails.
4. Remove the luggage carrier cross rail from the luggage carrier side rails.
INSTALLATION PROCEDURE
