Uplander AWD V6-3.5L VIN 8 (2005)
4. Install the lubricated boot (1) onto the brake caliper piston (2).
5. Lubricate the brake caliper piston (2) with clean brake fluid.
6. Install the brake caliper piston and the brake caliper piston boot into the bore of the caliper. Push the brake caliper piston to the bottom of the bore.
7. Seat the caliper boot in the caliper housing counterbore using the J 35777.
8. Install the caliper.
Brake Caliper Replacement - Rear
The content of this article reflects the changes identified in TSB Bulletin No. #05-05-26-004 dated December 14, 2005.
Subject:
Revised Park Brake Cable Replacement - Left Rear (with IRS) and Park Brake Cable Replacement - Right Rear (with IRS)
Brake Caliper Replacement - Rear
Caution: Refer to Brake Dust Caution in Service Precautions.
Caution: Refer to Brake Fluid Irritant Caution in Service Precautions.
Caution: Refer to Park Brake Cable to Caliper Caution in Service Precautions.
Notice: Refer to Brake Fluid Effects on Paint and Electrical Components Notice in Service Precautions.
Removal Procedure
1. Inspect the fluid level in the brake master cylinder reservoir.
2. If the brake fluid level is midway between the maximum-full point and the minimum allowable level, no brake fluid needs to be removed from the
reservoir before proceeding.
3. If the brake fluid level is higher than midway between the maximum-full point and the minimum allowable level, remove brake fluid to the
midway point before proceeding.
4. Raise and support the vehicle. Refer to Vehicle Lifting.
5. Remove the tire and wheel assembly.
