Uplander AWD V6-3.5L VIN 8 (2005)
11. Bleed the brake system.
12. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
13. Slowly release the brake pedal.
14. Wait 15 seconds, then repeat steps 12-13 until a firm brake pedal is obtained. This will properly seat the brake caliper pistons and brake pads.
15. Adjust the park brake system.
16. Install the tire and wheel assembly.
17. Lower the vehicle.
Brake Caliper Overhaul - Rear
Brake Caliper Overhaul - Rear
Removal Procedure
1. Caution: Refer to Brake Dust Caution in Service Precautions.
Caution: Refer to Brake Fluid Irritant Caution in Service Precautions.
Notice: Refer to Brake Fluid Effects on Paint and Electrical Components Notice in Service Precautions.
Remove the rear brake caliper from vehicle.
2. Important: If the brake caliper was leaking brake fluid from the REAR of the caliper past the integral park brake actuator shaft seal, replace the
brake caliper assembly. The park brake integral mechanism contains a non-serviceable seal which may be allowing brake fluid to leak past it and
into the non-serviceable integral park brake mechanism.
