Uplander AWD V6-3.5L VIN 8 (2005)
Important: Maintain proper rear park brake cable routing and clearances. Verify that the rear park brake cables have a minimum of 10 mm and a
maximum of 12 mm of clearance to the wheel drive shafts (1). Maintain this clearance using retention straps or equivalent retention (2).
9. Install the park brake cable into the park brake bracket on the caliper.
10. Connect the park brake cable to the park brake lever on the brake caliper.
11. Bleed the brake system.
12. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
13. Slowly release the brake pedal.
14. Wait 15 seconds, then repeat steps 12-13 until a firm brake pedal is obtained. This will properly seat the brake caliper pistons and brake pads.
15. Adjust the park brake system.
16. Install the tire and wheel assembly.
17. Lower the vehicle.
