Uplander AWD V6-3.5L VIN 8 (2005)
2. Install the master cylinder to the brake booster.
3. Notice: Refer to Fastener Notice in Service Precautions.
Install the master cylinder mounting nuts.
^
Tighten the nuts to 29 Nm (21 ft. lbs.).
4. Remove the plugs from the brake pipes
5. Connect the brake pipes to the master cylinder.
^
Tighten the fittings to 32 Nm (24 ft. lbs.).
6. Connect the electrical connector to the brake fluid level sensor.
7. Bleed the hydraulic brake system.