Uplander AWD V6-3.5L VIN 8 (2005)
Engine Mount: Testing and Inspection
Engine Mount Inspection
Important: Before replacing any engine mount due to suspected fluid loss, verify that the source of the fluid is the engine mount, not the engine
or accessories.
1. Install the engine support fixture.
2. Observe the engine mount while raising the engine. Raising the engine removes the weight from the engine mount and creates slight tension on the
rubber.
3. Replace the engine mount if the engine mount exhibits any of these conditions:
^
The hard rubber is covered with heat check cracks.
^
The rubber is separated from the metal plate of the engine mount.
^
The rubber is split through the center of the engine mount.
^
The engine mount itself is leaking fluid.