Uplander AWD V6-3.5L VIN 8 (2005)
Installation Procedure
1. If removed, install the HO2SL.
2. If removed, install the EGR valve pipe.
3. Raise and support the vehicle. Refer to Vehicle Lifting.
4. Install the exhaust manifold gasket.
5. Install the exhaust manifold.
6. Notice: Refer to Fastener Notice in Service Precautions.
Install the exhaust manifold nuts.
^
Tighten the exhaust manifold nuts to 16 Nm (12 ft. lbs.).
7. Install the exhaust manifold lower heat shield.
8. Install the exhaust manifold upper heat shield.
9. Install the exhaust manifold heat shield bolts.
^
Tighten the exhaust manifold heat shield bolts to 10 Nm (89 inch lbs.).
10. Install the catalytic converter.
11. Lower the vehicle.
12. Install the exhaust crossover pipe nuts/studs to the engine right side exhaust manifold.
13. Install the exhaust crossover pipe heat shield.
14. Lower the vehicle.
15. Connect the HO2S electrical connector.
16. Install the spark plug wires to the engine right bank spark plugs.
17. Install the ignition module and the ignition coils with the bracket.
18. Install the EGR valve to the intake manifold.
19. Install the MAP sensor.
