Uplander AWD V6-3.5L VIN 8 (2005)
1. Install the mode actuator (2).
2. Install the mode actuator bolts/screws (1).
Tighten the screws to 1.2 N.m (11 lb in).
NOTE: Refer to Fastener Notice in Service Precautions.
3. Connect the mode actuator electrical connector (3).
4. Install the driver side knee bolster.
5. Re-calibrate the actuators. Refer to Re-Calibrating Actuators.
Mode Actuator - Auxiliary
MODE ACTUATOR REPLACEMENT - AUXILIARY
REMOVAL PROCEDURE