Uplander AWD V6-3.5L VIN 8 (2005)
14. Remove the auxiliary blower motor housing screws.
15. Remove the auxiliary blower motor housing from the HVAC module.
16. Remove the auxiliary HVAC module case screws.
17. Separate the auxiliary HVAC module case halves.
18. Remove the auxiliary evaporator core from the lower HVAC module case.
INSTALLATION PROCEDURE
1. If replacing the auxiliary evaporator core add the specified amount of PAG oil directly to the auxiliary evaporator core. Refer to Refrigerant
System Capacities.
2. Install the auxiliary evaporator core into the lower HVAC module case.
3. Assemble the auxiliary HVAC module case halves.
4. Install the auxiliary HVAC module case screws.
Tighten the screws to 1.6 N.m (14 lb in).
NOTE: Refer to Fastener Notice.
5. Install the auxiliary blower motor housing to the HVAC module.
6. Install the auxiliary blower motor housing screws.
Tighten the screws to 1.6 N.m (14 lb in).
7. Install the auxiliary temperature actuator to the auxiliary HVAC module.
8. Install the auxiliary temperature actuator screws.
Tighten the screws to 1.6 N.m (14 lb in).
9. Install new sealing washers to the auxiliary evaporator core.
10. Remove cap or tape from the A/C lines.
