Uplander AWD V6-3.5L VIN 8 (2005)
6. Connect the steering wheel module coil yellow connector (1).
7. Install the CPA to the steering wheel module coil connector (1) located at the base of the steering column.
8. Install the left I/P insulator panel.
9. Connect the vehicle harness connector (4) to the LF side impact module yellow connector (1).
10. Install the CPA to the LF side impact module connector (1).
11. Connect the I/P module yellow connector (1).
12. Install the CPA (2) to the I/P module connector (1).
13. Install the right I/P insulator panel.
14. Connect the vehicle wiring harness connector to the right seat belt retractor pretensioner.
15. Install the CPA to the right seat belt retractor pretensioner connector.
16. Install the right lower center pillar trim cover.
