Uplander AWD V6-3.5L VIN 8 (2005)
1. Install the O-ring seal (11) to the vehicle speed sensor (10).
2. Install the vehicle speed sensor to the extension case.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the vehicle speed sensor bolt (9).
^
Tighten the bolt to 12 Nm (106 inch lbs.).
4. Connect the vehicle speed sensor wiring harness connector.
5. Install the right engine splash shield.
6. Install the right front tire and wheel. Tire and Wheel Removal and Installation.
7. Lower the vehicle.
