Uplander AWD V6-3.5L VIN 8 (2005)
Ignition Cable: Service and Repair
SPARK PLUG WIRE REPLACEMENT
REMOVAL PROCEDURE
1. Remove the spark plug wires (2,4, and 6) from the engine left side spark plugs.
NOTE: Twist the spark plug boot one-half turn in order to release the boot. Pull on the spark plug boot only. Do not pull on the spark plug wire or
the wire could be damaged.
2. Remove the spark plug wires from the retaining clips.
3. Rotate engine for access to back of engine. Refer to Rotating the Engine for Service Access.
4. Remove the spark plug wires (1,3, and 5) from the engine right side spark plugs.
5. Remove the spark plug wires from the retaining clip.