Uplander AWD V6-3.5L VIN 8 (2005)
Tighten the nuts to 10 N.m (89 lb in).
5. Connect the wiring harness (1) to the actuator control module (3).
6. Route the rear cable (2) through the opening in the rear sliding door center track.
NOTE: Use care when feeding cables to and from the center track and body to avoid damage to the coated cables and the vehicle's painted surface.
7. Position the rear pulley to the rear inner quarter panel.
8. Install the rear pulley bolts.
Tighten the bolts to 10 N.m (89 lb in).
9. Install the cover (2).