chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

ABOUT US
Deployment Outside Vehicle - Steering Wheel Module, I/P Module, And Side Impact Module|Page 12955 > < Deployment Outside Vehicle - Steering Wheel Module, I/P Module, And Side Impact Module|Page 12953

Uplander AWD V6-3.5L VIN 8 (2005)

Page 8
background image

19. Secure and insulate the 3-wire connection to deployment harness using electrical tape.

20. Connect the deployment harness to the steering wheel module in-line connector.

21. Route the deployment harness out of the driver side of the vehicle.

22. Disconnect the driver side impact module yellow connector (1) from the vehicle wiring harness (4) located under the driver seat.

23. Cut the 2 side impact module wires leading to the yellow harness connector, leaving at least 16 cm (6 in) of wire at the connector.
24. Strip 13 mm (0.5 in) of insulation from each of the side impact module connector wire leads.

Deployment Outside Vehicle - Steering Wheel Module, I/P Module, And Side Impact Module|Page 12955 > < Deployment Outside Vehicle - Steering Wheel Module, I/P Module, And Side Impact Module|Page 12953