Uplander AWD V6-3.5L VIN 8 (2005)
14. Disconnect the upper control arm from the knuckle.
15. Using the J 41820, disconnect the lower ball joint from the knuckle.
16. Remove the knuckle.
17. Remove the wheel speed sensor connector bracket from the knuckle.
Installation Procedure
Important: Maintain proper rear park brake cable routing and clearances. Verify that the rear park brake cables have a minimum of 10 mm and a
maximum of 12 mm of clearance to the wheel drive shafts (1). Maintain this clearance using retention straps or equivalent retention (2).
1. Install the wheel speed sensor connector bracket to the knuckle.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the wheel speed sensor connector bracket bolt and nut.
^
Tighten the wheel speed sensor bracket nut to 12 Nm (106 inch lbs.).
3. Install the knuckle.
4. Connect the lower ball joint to the knuckle.
^
Tighten the ball joint nut to 60 Nm (44 ft. lbs.).
